| Part | Photo | Location | Frequency | Description |
|---|---|---|---|---|
| Air Filter | ![]() |
top rear of engine | weekly or as needed | remove foam filter from casing and clean with water, dry completely before installing |
| Head Bolts | ![]() |
top of engine block | every 5 hours of run time | tighten the four bolt heads in X pattern to 12ft/lbs |
| Drive Chain | ![]() |
left side of engine | before riding | press down on chain, if it deflects more than 15mm, adjust tensioner |
| Spark Plug | ![]() |
top center of engine | monthly | remove spark plug, check gap (.6mm-.7mm), check condition of plug, replace if cracked or broken |
| Clutch | ![]() |
left side of handle bars | before each ride | pull in clutch lever and lock, bike should roll freely (motor should not turn over). If it doesn't roll freely, tighten clutch cable on the back end of the engine |
| Rider | ![]() |
top of bike | before each ride | Check for sobriety, helmet, lighting and common sense. If any of these things are not present, remove rider. |
Ensure all nuts and bolts on engine/rear sprocket/bike are tight before each ride.
Test brakes before each ride.
Proper oil to gas ratio is essential to prevent engine seizure.
(mix gas and oil in seperate container before adding to tank)
828.776.1630








